How do you approach sizing services, feeders and panels on a larger job, and planning for future load?

What the interviewer is looking for

• This question tests load calculations & circuit design. Explains sizing of conductors, breakers and services and checks capacity before adding load.
• Strong answers: Performs code-based load calculations, applies demand factors, considers voltage drop and future expansion like electric vehicles or solar, and coordinates with the engineer and utility.
• Likely follow-up: How do you handle it when the owner wants to cut cost by downsizing?

Another way it may be asked: A small office building is being fitted out. How do you decide how big the electrical service should be?

A structure to follow: Answer, explain, example, limits

1. Step 1

   Answer

   Give your direct answer in the first sentence so the interviewer knows where you are going.

2. Step 2

   Explain

   Say how it works or why you would do it that way, in plain words before jargon.

3. Step 3

   Example

   Anchor it in something you have actually done or seen, with the detail that shows hands-on experience.

4. Step 4

   Limits

   Say when your approach would not be the right one. It shows judgement.

This is guidance on shape, not a script. Use your own real experience and facts; never invent details to fill a gap. See the STAR guide and answer frameworks.

Common slips

• Reciting a definition without showing you have applied it.
• Using terms you cannot explain if asked a level deeper.
• Claiming experience beyond what you can discuss in detail.

How to practise it

Say the answer in 90 seconds, then answer the follow-up as if it were a new question.

Related questions

• A homeowner wants to add an electric vehicle charger. How would you check whether their service and panel can handle it?
• Before you work on a circuit, walk me through the steps you take to make sure it's safe.
• Can you explain what the hot, neutral and ground wires each do in a typical circuit?
• The job starts at seven and you're stuck in traffic. What do you do?
• A customer says a breaker keeps tripping. Walk me through how you'd find the cause.

Browse all questions